Technology for the construction of plastic windows: main points
The window profile should be set in level both horizontally and in vertically.
When driving wedges, look do not overdo it, because the profile can burst or flush the welds.
We fix the window.
After the window is set exactly by level and fixed using wedges with self -tapping screws, we screw the profile to the window opening. At this stage, the main thing is not to pull the frames. If the screws are tightened hard, the window profile can take a barrel -shaped form, which is completely unnecessary.
Starrier for double -glazed windows.
After that, carefully insert the double -glazed window in its place, while you need to not forget to put special stands for the double -glazed window.
We insert a double -glazed window.
Next, we insert a glazing tape, and as I said, you need to start from the short sides and end with long. If the glazing man comes in tightly, it is permissible to knock it with a rubber hammer.
STATION OF SHAST.
Installation of plastic windows.
At the next stage, we displeers the gap between the window opening and the window profile. Be careful to dump only after installing double -glazed windows, otherwise the window profile can become concave inside and the double -glazed window then simply does not get into the profile.